diff options
Diffstat (limited to 'locale/sv.po')
| -rw-r--r-- | locale/sv.po | 52 |
1 files changed, 49 insertions, 3 deletions
diff --git a/locale/sv.po b/locale/sv.po index 47739e4aa..db8d6a2d9 100644 --- a/locale/sv.po +++ b/locale/sv.po @@ -5,7 +5,7 @@ msgid "" msgstr "" "Project-Id-Version: PACKAGE VERSION\n" "Report-Msgid-Bugs-To: \n" -"POT-Creation-Date: 2020-11-24 15:40-0500\n" +"POT-Creation-Date: 2020-11-27 23:57-0500\n" "PO-Revision-Date: 2020-11-30 18:06+0000\n" "Last-Translator: Jonny Bergdahl <jonny@bergdahl.it>\n" "Language-Team: LANGUAGE <LL@li.org>\n" @@ -504,7 +504,8 @@ msgstr "Buffertlängd måste vara en multipel av 512" msgid "Buffer must be a multiple of 512 bytes" msgstr "Bufferten måste vara en multipel av 512 byte" -#: shared-bindings/bitbangio/I2C.c shared-bindings/busio/I2C.c +#: shared-bindings/bitbangio/I2C.c shared-bindings/busdevice/I2CDevice.c +#: shared-bindings/busio/I2C.c msgid "Buffer must be at least length 1" msgstr "Bufferten måste ha minst längd 1" @@ -856,6 +857,10 @@ msgstr "Förväntade en UUID" msgid "Expected an Address" msgstr "Förväntade en adress" +#: shared-bindings/alarm/__init__.c +msgid "Expected an alarm" +msgstr "" + #: shared-module/_pixelbuf/PixelBuf.c #, c-format msgid "Expected tuple of length %d, got %d" @@ -1001,6 +1006,10 @@ msgstr "I2C init-fel" msgid "I2SOut not available" msgstr "I2SOut är inte tillgängligt" +#: ports/esp32s2/common-hal/alarm/pin/__init__.c +msgid "IOs 0, 2 & 4 do not support internal pullup in sleep" +msgstr "" + #: shared-bindings/aesio/aes.c #, c-format msgid "IV must be %d bytes long" @@ -1302,6 +1311,11 @@ msgstr "Ingen DAC på chipet" msgid "No DMA channel found" msgstr "Ingen DMA-kanal hittades" +#: shared-module/busdevice/I2CDevice.c +#, c-format +msgid "No I2C device at address: %x" +msgstr "" + #: ports/esp32s2/common-hal/busio/SPI.c ports/mimxrt10xx/common-hal/busio/SPI.c #: ports/stm/common-hal/busio/SPI.c msgid "No MISO Pin" @@ -1460,6 +1474,10 @@ msgstr "" "Endast monokrom, indexerad 4 bpp eller 8 bpp och 16 bpp eller högre BMP: er " "stöds: %d bpp angiven" +#: ports/esp32s2/common-hal/alarm/__init__.c +msgid "Only one alarm.time alarm can be set." +msgstr "" + #: shared-module/displayio/ColorConverter.c msgid "Only one color can be transparent at a time" msgstr "Bara en färg kan vara genomskinlig i taget" @@ -1519,6 +1537,10 @@ msgstr "Pinnen måste stödja hårdvaruavbrott" msgid "Pin number already reserved by EXTI" msgstr "PInn-nummer redan reserverat av EXTI" +#: ports/esp32s2/common-hal/alarm/__init__.c +msgid "PinAlarm not yet implemented" +msgstr "" + #: shared-bindings/rgbmatrix/RGBMatrix.c #, c-format msgid "" @@ -1588,7 +1610,7 @@ msgstr "RS485-inversion specificerad när den inte är i RS485-läge" msgid "RTC calibration is not supported on this board" msgstr "RTC-kalibrering stöds inte av detta kort" -#: shared-bindings/time/__init__.c +#: shared-bindings/alarm/time/TimeAlarm.c shared-bindings/time/__init__.c msgid "RTC is not supported on this board" msgstr "RTC stöds inte av detta kort" @@ -1734,6 +1756,10 @@ msgstr "Stream saknar readinto() eller write() metod." msgid "Supply at least one UART pin" msgstr "Ange minst en UART-pinne" +#: shared-bindings/alarm/time/TimeAlarm.c +msgid "Supply one of monotonic_time or epoch_time" +msgstr "" + #: shared-bindings/gnss/GNSS.c msgid "System entry must be gnss.SatelliteSystem" msgstr "Systeminträdet måste vara gnss. SatellitSystem" @@ -1805,6 +1831,10 @@ msgstr "Tile-värde utanför intervall" msgid "Tile width must exactly divide bitmap width" msgstr "Tile-bredd måste vara jämnt delbar med bredd på bitmap" +#: shared-bindings/alarm/time/TimeAlarm.c +msgid "Time is in the past." +msgstr "" + #: ports/nrf/common-hal/_bleio/Adapter.c #, c-format msgid "Timeout is too long: Maximum timeout length is %d seconds" @@ -2534,6 +2564,10 @@ msgstr "slut på format vid sökning efter konverteringsspecificerare" msgid "end_x should be an int" msgstr "color ska vara en int" +#: shared-bindings/alarm/time/TimeAlarm.c +msgid "epoch_time not supported on this board" +msgstr "" + #: ports/nrf/common-hal/busio/UART.c #, c-format msgid "error = 0x%08lX" @@ -2903,6 +2937,10 @@ msgstr "ogiltig syntax för heltal med bas %d" msgid "invalid syntax for number" msgstr "ogiltig syntax för tal" +#: ports/esp32s2/common-hal/alarm/pin/__init__.c +msgid "io must be rtc io" +msgstr "" + #: py/objtype.c msgid "issubclass() arg 1 must be a class" msgstr "issubclass() arg 1 måste vara en klass" @@ -3596,6 +3634,10 @@ msgstr "för många värden att packa upp (förväntat %d)" msgid "trapz is defined for 1D arrays of equal length" msgstr "trapz är definierad för 1D-matriser med samma längd" +#: ports/esp32s2/common-hal/alarm/pin/__init__.c +msgid "trigger level must be 0 or 1" +msgstr "" + #: extmod/ulab/code/linalg/linalg.c msgid "tuple index out of range" msgstr "tupelindex utanför intervallet" @@ -3738,6 +3780,10 @@ msgstr "value_count måste vara > 0" msgid "vectors must have same lengths" msgstr "vektorer måste ha samma längd" +#: ports/esp32s2/common-hal/alarm/pin/__init__.c +msgid "wakeup conflict" +msgstr "" + #: ports/esp32s2/common-hal/watchdog/WatchDogTimer.c msgid "watchdog not initialized" msgstr "watchdog är inte initierad" |