blob: f2332bbe54ad16f3ca93574a8ea918138436f5d9 (
plain)
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
|
#define MICROPY_HW_BOARD_NAME "BDMICRO VINA-D21"
#define MICROPY_HW_MCU_NAME "samd21g18"
// These are pins not to reset.
#define MICROPY_PORT_A (0)
#define MICROPY_PORT_B (0)
#define MICROPY_PORT_C (0)
#define SPI_FLASH_CS_PIN &pin_PA13
#define SPI_FLASH_MISO_PIN &pin_PB03
#define SPI_FLASH_MOSI_PIN &pin_PB22
#define SPI_FLASH_SCK_PIN &pin_PB23
// Clock rates are off: Salae reads 12MHz which is the limit even though we set it to the safer 8MHz.
#define SPI_FLASH_BAUDRATE (8000000)
#define BOARD_HAS_CRYSTAL 1
#define DEFAULT_UART_BUS_TX (&pin_PA10)
#define DEFAULT_UART_BUS_RX (&pin_PA11)
#define DEFAULT_SPI_BUS_MISO (&pin_PA12)
#define DEFAULT_I2C_BUS_SDA (&pin_PA22)
#define DEFAULT_I2C_BUS_SCL (&pin_PA23)
#define MICROPY_HW_LED_TX (&pin_PA27)
#define MICROPY_HW_LED_STATUS (&pin_PA28)
#define MICROPY_HW_LED_RX (&pin_PA31)
#define DEFAULT_SPI_BUS_MOSI (&pin_PB10)
#define DEFAULT_SPI_BUS_SCK (&pin_PB11)
// USB is always used internally so skip the pin objects for it.
#define IGNORE_PIN_PA24 1
#define IGNORE_PIN_PA25 1
|
